Company about
Home > Polaris Sportsman > Polaris 500 4x4 Not Working

Polaris 500 4x4 Not Working


I also take it that you will be the only person using the ATV, and if not, you would need to brief the rider on the new arrangement. Figure 4: Location of the likely bad part(s). Newsletter Archive Brand Discussions Area Vintage Machines.. Wire 2 is "hot" when the harness is not plugged in and the awd switch is on.

I think it is used to calibrate the speedometer but not sure. I would expect something like "1k" or "50k" (e.g. 1-3 numbers followed by the letter "k" or, less likely some numbers in front of "M") or just three numbers together - If you don't have any of these it will be challenging to get the through-holes cleared to install the replacement components without tearing traces off the board. Users have self organized get togethers and many have formed long lived friendships with others who share the same interests in the outdoors through the site.

2007 Polaris Sportsman 500 Awd Not Working

The hub coils should read around 24 ohms each. There are two other screws, each located 1/3rd of the way around on either side: Remove those, too. I'll update once I get the new transistors in the mail and installed. And there is no visible burn marks or damage...

  1. I did the suggested repairs and when I placed my 1999 polaris sportsman 500 speedometer back in, it worked as it should.
  2. Could it be something else any thoughts?Thanks!ReplyDeleteRepliesKA7OEIJanuary 12, 2016 at 5:21 PMFirst check the supply voltage to the speedo: It should be pretty much that of the battery.If that is OK
  3. Loading...
  4. Repair of the speedometer requires some knowledge of electronics and board-level electrical components.
  5. to see if you have voltage.
  6. I take it the handlebar switch also goes to the speedometer, to give AWD indication, and is connected internally to these wires.

im gonna give it a shot. It was a social network before the term was coined. Again your bypass will probably work but the overspeed in reverse will be a hazard to someone that is not familiar with the machine and open you up to liability. Polaris Sportsman 500 Speedometer Not Working The 4x4 light comes on but only the back wheels spin.

If you do this, now is the time to double-check that the needle points at zero. Polaris Sportsman 400 4x4 Not Working Need to check switch continuity??...pray its not a front hub/clutch prob. mossman381 118,089 views 12:50 How to Test Circuit Breakers on a Polaris Sportsman ATV - Electrical Issue DIY - Duration: 4:28. headin to try your theory out now.

that makes sense, when i rip it apart, anything i should be looking for? 2005 Polaris Sportsman 500 4x4 Not Working If you look carefully, you will notice markings on the upper-left edge of the LCD which may be used to indicate which way is up. Before you start, read this entire posting so that you'll know what you are in for! Share this conversation Related Motorcycle Questions Question Date Submitted Louis, with this kind of caburertor, where is the air valse, 11/12/2016 11/12/2016 Benimur ATVCan-Am no electrical power, nothing.

Polaris Sportsman 400 4x4 Not Working

Sometimes and not sure on this model you have an electic actuator that when it gets wet and freeze up it will not engage the half shaft for the front end. Help With Forum Software! 2007 Polaris Sportsman 500 Awd Not Working The other two screws are located 1/3rd of the way around, at approximately "10" and "40" MPH. Polaris Sportsman Awd Not Engaging If you can't figure out what wires they are pm me and I will pop the cover on mine and look. #5 Jonesboys Mud Master Total Posts : 518 Reward

Thanks for the great post.DeleteKA7OEIMarch 30, 2016 at 3:27 PMSorry to hear that - I (and, no doubt you!) were hoping for a better result.There are at least two voltage regulators my review here If your current-limited power supply "sees" a dead short, remove power immediately and check for solder bridges around the components that were replaced. It has not been rode hard. I just purchased a 99 sportsman 500 that had a bad battery and apparently impacted the system. 2004 Polaris Sportsman 500 4x4 Problems

HELP using the forum / swap shop House hunting Active Posts Operation Big Bore Hooptie 10 build for mudaholic convention 30 inch zillas? It tells you step by step on how to fix your front hubs. I'm not sure how anyone was adding attachments to their comments as I don't see an option to do so. click site I would trace the wires to make sure a rat or something has not chewed the wires in half.

Figure 2: By carefully prying up the speedometer face's plastic, you can access the three screws that hold the module in the body. Polaris Sportsman Speedometer Bypass goproatver 1,172 views 3:10 1997 Polaris 500 how Hilliard clutch works - Duration: 7:39. yes the front u joint is bad has lots of play in it.

Comment: I occasionally get asked a question via this blog's comment tool.

Last month our 250 did the same thing! Any quick way to do the audio Audio HZ test? Last year, a friend of mine had the battery go bad on his 1999 Polaris Sportsman 500 4-wheeler. 2001 Polaris Sportsman 500 Speedometer Not Working Be back tomorrow morning for anymore help if it turns out not to be the coils or bad connection.

the same thing happened to my pull starter i have one ordered to replace it too. still no light on the switch coming on. No biggy, sounds like you answered my question enough to explain why mine didn't look 100% as yours did. One side note, the 2000 Polaris had a circuit board with more surface mount components.

Once you have the cover off, set it aside with the black, plastic rod laying inside the cover. Up next Polaris Sportsman 500 4x4 AWD fix - Duration: 1:46. Check out that web site I posted. No fear though, if you use the search option on this site you will find a easy wiring bypass trick to have AWD without buying a $300 Speedometer.

Pre 1975, Dirt bikes, ATV's, MiniBikes, Snowmobiles, etc.... Also check the armature plate while your in there.