Company about
Home > Polaris Sportsman > Polaris Sportsman Lights Not Working

Polaris Sportsman Lights Not Working


Unfortunately, I've never seen one of those in person, or else I would have documented a repair for it.As for pictures, people have attached them to their comments here and I Using your phone or camera, take some close-up pictures of both sides of the board before you start as a possible aid in reassembly. When I pushed start switch voltage dropped to around 4 volts. switch that just controls the hot light.

the grounds are all good. Pa with the temp sensor unplugged i beleive that the fan should run all the time. Watch Queue Queue __count__/__total__ Find out whyClose How to get your work lights to work on your ATV (2008 Polaris 500 Sportsman H.O.) Josh Wiley SubscribeSubscribedUnsubscribe1616 Loading... Would there be a fuse or circuit breaker somewhere i may be missing?

Polaris Sportsman Fuse Box Location

Is the needle suppose to be real easy to turn? Back to top Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed tech857 Posted February 04, 2010 - 04:27 PM #3 Have you When you replaced the breaker was it all corroded?

  1. Once you have the cover off, set it aside with the black, plastic rod laying inside the cover.
  2. The unit must be powered up in order for the speedometer - and odometer, for that matter - to indicate.
  3. When looking for replacement caps Mine say 25v 470 micro farad CKRM M85 C what is CKRM?But when I go to digikey there are other specs like ripple current and series
  4. vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.
  5. huntininmilan12-18-2006, 10:31 AMi have the same issue on my 1998 sportsman 500 in that i keep blowing the 2 lower bulbs at $25.00 each and the headlight at auto zone $10.00.,
  6. Do you have a test light and multi meter?Edited by mcatlin on 12/2/2009 at 11:55 PM EST Ask Your Own Motorcycle Question Share this conversation Related Motorcycle Questions Question Date Submitted
  7. Figure 2: By carefully prying up the speedometer face's plastic, you can access the three screws that hold the module in the body.
  8. Loading...
  9. Mudders Online 0 Members (), 33 Guests and 9 Spiders online.
  10. Never worked the same.

HELP!! Sometimes this is obvious (bulging, leaking, etc.) but not necessarily.If you are careful you should be able to connect the speedo without putting it in the case, but while the pins/connectors Add to Want to watch this again later? Polaris Sportsman 500 Speedometer Not Working i took off the hood cover and started jiggling the harness around and the headlight cam on.

It worked on mine.DeleteReplyRussell HeapMarch 17, 2015 at 10:36 PMThe speedo on my 2001 Sportsman 500 went bad and was replaced. 2000 Polaris Sportsman 500 Lights Not Working I was wondering if you had some more detailed information that you could post or send me.Many thanksReplyDeleteRepliesKA7OEIJanuary 18, 2015 at 11:11 AMWhat you see in Figure 5 is a generic Loading...

Using a small blade screwdriver, work your way around the perimeter of the inside of the speedometer, wedging gently between the outer body of the speedometer and the module itself, reaching

LinkBack Thread Tools Display Modes #1 (permalink) 12-26-2009, 05:25 PM CrazyFazy ATV Enthusiast Member #2427 Join Date: Dec 2009 Location: Lonaconing,MD Posts: 30 headlight problem on sportsman 500 2007 Polaris Sportsman 500 Fuse Box any auto store will have the same breaker for like $3.00. PLEASE NOTE:While I DO appreciate comments, those comments that are just vehicles to other web sites without substantial content in their own right WILL NOT be posted!If you include a link Soldered it back on and its working like a champ.ReplyDeletepolydac1November 29, 2014 at 6:48 PMThanks for posting this as it was very helpful!

2000 Polaris Sportsman 500 Lights Not Working

Connecting one side (the shell of the connector going to the speaker) to ground and the inner pin to that which would go to the wheel sensor and then *slowly* increase The wires and colors will all be in there for you to trace.....Caper...... __________________ Sportsman 450 Blue (mine) warn and rear seat/box Sportsman 450 Yellow Wife's STOCK PowerMax 150cc Blue Daughters Polaris Sportsman Fuse Box Location No, I won't repair your speedometer as with shipping, time, "hassle factor" and labor, I'd have to charge a sizable percentage of the cost of a new one. Polaris Sportsman 400 Fuse Location Looks like I have my usual "worst luck." I did check eBay again today and got a NIB for $300 instead of $400, so I suppose that's my silver lining.Again, great

If they are stuck to the board, very carefully remove them, but if they are stuck to the LCD, don't worry. my review here When you pull on the needle make sure that the speedometer is on the workbench with padding on it because if it comes off suddenly, you don't want to slam your My uncle had the same quad with the same problem. What (probably) happens: It's probably not the high voltage that actually kills the speedometer: The voltage regulator circuit in the speedometer seems to be fairly robust, using high voltage (>=300 volt) Polaris Sportsman 500 Wiring Diagram Pdf

Assume from the beginning that the speedometer is a total write-off and that you would have to replace it, anyway, to get it working again. Show more Language: English Content location: United States Restricted Mode: Off History Help Loading... Pa Marshall, I just looked at the wiring schematic and seen thatb there is an Engine Temp. click site If it is *way* below the voltage, one or more of the parts mentioned in the posting may be damaged - particularly the Zener.

I'll update once I get the new transistors in the mail and installed. 2004 Polaris Sportsman 400 Wiring Diagram Loading... Very strange.

Thanks Randy, and also thank you VERY MUCH for your help.

Loading... Loading... I just talked to a friend of mine about your problem and he tells me that it might be a switch problem check to see if there is power going into 2005 Polaris Sportsman 500 Fuse Box Salt & Fresh Water.

There have been reported instances where the parts have gotten so hot that the solder has melted and that they have simply fallen out: If this is the case with your Not sure what it is but figure its what makes the needle turn. If you can't get the needle off before this step, make sure that you move it out of the way when you pry up on the faceplate so that you don't navigate to this website In testing the speedometer after the repair I applied 20 volts to it and the main regulator transistor soon got too hot to touch: If this had been a hot, summer

I know ONLY about the speedometers on Polaris Sportsman 500's for the years 1999 and 2000: If you ask me about speedometers for any other make, year or model, I can't Do NOT use a soldering gun for this repair work: If that's all that you have, you really should not try it as you'll likely ruin the board! While both versions seem to have the same fate when used with a bad battery - and the "fix" is likely similar, I have not personally seen the newer surface-mount version.